Seal Krete 100001 Clear Acrylic Original Water Proofing Primer/Sealer,

SEAL-KRETE® ORIGINAL Waterproofing Primer/Sealer protects vertical concrete and masonry against the damaging effects of moisture penetration. It penetrates deeply into concrete pores, binding sand and cement particles to form a tough, flexible, breathable film. Original is excellent for binding chalky surfaces to improve paint adhesion on all painted and unpainted substrates including concrete block, stucco, aluminum siding, drywall, and plaster. It strengthens mortar joints, reduces efflorescence on brick, and rejuvenates color on older painted surfaces like aged vinyl siding and stucco.

• Size: 1 Gallon
• Protects New or Painted Masonry
• Revitalizes Color, Non-Yellowing
• Resists Mold & Mildew Growth
• Binds Chalky Surfaces
• Strengthens Mortar Joints
• Seals Painted Metal
• Rejuvenates Faded Vinyl.

Application:

• Read “LIMITATIONS” section before use. This sealer is ready to use; do not dilute. Apply with a brush, roller or sprayer (garden or airless). Backroll spray applications to ensure penetration. Apply at least two coats, allowing two hours dry time between coats. Remove any overspray immediately with water. Note: Sealer goes on milky white but dries clear.

Coverage:

• 80–300 sq.ft. per gal., depending on surface porosity. Second coat application is 50% greater. Two coats are required for waterproofing bare, vertical concrete.

Dry Time:

• 2–4 hours, depending on temperature and humidity.

Topcoating:

• May be topcoated with latex, oil-based or elastomeric coating when dry.

Tint Limits:

• Up to 4 oz. colorant per gallon.

Paint Additive:

• 4–8 oz. of SEAL-KRETE Original can be mixed with one gallon of latex paint to improve spread rate.

Clean-Up & Storage:

• Clean all tools immediately after use with soap and water. Store unused product in a dry place above 32°F (0°C). KEEP FROM FREEZING.

Limitations:

• Use on above grade vertical surfaces or as a primer on horizontal surfaces – not for below grade use. Do not apply if rain is expected within 12 hours or if temperatures fall below 50°F within 24 hours of application. Do not use on swimming pools, bird baths, water features, cedar, redwood or in areas where hydrostatic pressure is likely to develop. Do not use on very porous substrates like low density, decorative block (use SEALKRETE Heavy-Duty instead).

Typical Uses:

• Seal brick, stucco & concrete  
• Rejuvenate old brick & plaster
• Brighten aluminum siding
• Prime vinyl siding
• Bind chalky surfaces
• Paint additive to extend life & coverage
• Buffer pH in hot cement
• Dustproofing and priming floors.

Caution:

• Avoid contact with eyes and prolonged contact with skin. Do not ingest. In case of eye contact, flush thoroughly with water. For skin contact, wash with soap and water. If swallowed, do not induce vomiting. Drink 1–2 glasses of water and get medical attention. (Keep Out Of Reach Of Children).